0

Out of 0 Ratings

Owner's of the APC Baby Monitor NETBOTZ gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 40
 
NetBotz 455 Installation and Quick Configuration Manual 5
Rear
Item Description
Microphone jack Supports audio sensing, audio recording, and two-way audio.
Maximum length of microphone cable: 3 m (9.8 ft).
Speaker jack Supports two-way audio.
Maximum length of speaker cable: 3 m (9.8 ft).
A-Link port Used for cascading NetBotz sensor pods and temperature and humidity
sensors with digital displays. Provides communications and power to the
connected devices over standard CAT-5 cabling with straight-through
wiring. For details, see “Connect Sensors and Sensor Pods to A-Link
Ports” on page 14.
10/100 Base-T
network port
Provides for a 10/100 Base-T network connection and power through
Power-over-Ethernet (PoE). Status and link LEDs indicate network
traffic:
Status LED—blinks orange and green at start-up; indicates the status of
the network connection (solid green—IP address established; blinking
green—attempting to obtain an IP address).
Link LED—blinks to indicate network traffic (green—connected at 10
Mbps; orange—connected at 100 Mbps).
Sensor ports (4) Used for connecting APC sensors, third-party dry-contact sensors, and
standard third-party 0-5 V sensors. Third-party dry-contact state sensors
require the NetBotz Dry Contact Cable (NBES0304). Standard
third-party 0-5 V sensors require the NetBotz 0-5 V Sensor Cable
(NBES0305).