3.8

Out of 1 Ratings

Owner's of the Motorola Headphones Motorola Tx500 Self Install Car Kit gave it a score of 3.8 out of 5. Here's how the scores stacked up:
  • Reliability

    3.0 out of 5
  • Durability

    3.0 out of 5
  • Maintenance

    5.0 out of 5
  • Performance

    5.0 out of 5
  • Ease of Use

    3.0 out of 5
of 25
 
11
Using Your Car Kit
Training the Car Kit
To train the car kit’s Voice Recognition, follow these steps:
1
Make sure your phone’s keypad tones are set to normal tones. (Refer to the user’s guide
for your phone for information about using your phone’s Settings menu to define keypad
tones.)
If the Bluetooth Button
E
is not lit, press it to establish a Bluetooth link.
2
Press and hold the Voice Recognition Button until it begins to flash.
3
Train the car kit by using the commands described in “Training Commands” below.
4
To exit Training Mode, press and release the Voice Recognition Button.
Training Commands
The following sections describe the commands used in Training Mode to train your car kit’s
Voice Recognition.
Note:
To use the functions described below, a Bluetooth link must be established between
the car kit and your phone.
Each section shows you how to enter each command as follows:
H
# 2 #
The
H
symbol means that you should press the keys indicated. In this example, you would
press your phones
#
key, followed by the
2
key, then the
#
key again.
H
# 5 # Language Selection
Allows you to choose a language used by Voice Recognition when it prompts you with
instructions. After you enter this command, you can step through a list of languages.
Press
*
to advance through the list,
#
to go back.
Press any other number key to select a language.
H
# 6 # Key Word On/Off
Used to activate and deactivate the key word. The key word can be set to
On
or
Off
.
When the key word is set to
On
, you can answer an incoming phone call by pronouncing the
keyword (not compatible with music tone ringer).
H
# 2 # Record Key Word
Used to record the key word described above.
The key word is attached to a single user and cannot be used by anyone else. Other users
must activate Voice Recognition by pressing the Voice Recognition Button and then saying
names that they have recorded.
During normal recording, you are required to say the name twice.
To exit this mode, press any key.
To distinguish the key word from other words spoken during a normal conversation, and to
prevent the key word from being activated accidentally, follow these guidelines:
Select a key word made of 2- 3 words.