D-Link Breast Pump Dual Band PoE Access Point User Manual

0

Out of 0 Ratings

Owner's of the D-Link Breast Pump Dual Band PoE Access Point gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 95
 
88D-Link DAP-2690 User Manual
Section 4 - Using the Console Port
Troubleshooting
This chapter provides solutions to problems that can occur during the installation and operation of the DAP-2690 Wireless Access Point. We will
cover various aspects of the network setup, especially the network adapters. Please read the following if you are having any technical diculties.
Note: It is recommended that you use an Ethernet connection to congure the DAP-2690.
1. The computer used to congure the DAP-2690 cannot access the Conguration menu.
• Check if the LAN LED on the DAP-2690 is ON. If the LED is not ON, check if the cable for the Ethernet connection is securely inserted.
• Check if the Ethernet adapter is working properly. Please see item 3 of this Troubleshooting section to check that the drivers for the network
adapters are loaded properly.
• Check if the IP address is in the same range and subnet as the DAP-2690.
Note: The default IP address of the DAP-2690 is 192.168.0.50. All the computers on the network must have a unique IP address in the same range, e.g.
192.168.0.x. Any computers that have identical IP addresses will not be visible on the network. They must all have the same subnet mask, e.g. 255.255.255.0.
• Perform a Ping test to make sure that the DAP-2690 is responding. Go to Start > Run, type cmd, and then press Enter. At the DOS prompt,
type ping 192.168.0.50. A successful ping will show four replies.
Note: If you have changed the default IP address, make sure to ping the correct IP address assigned to the DAP-2690.

   Find Your Products By Category