3M Projector Mobile Projector User Manual

0

Out of 0 Ratings

Owner's of the 3M Projector Mobile Projector gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 48
 
3M™ Mobile Projector MP300
38 © 2012 3M. All Rights Reserved.
The status indicator on the projector flashes red.
• The projector's battery needs to be charged.
Setting Up the Projector
The projector falls over when I place it on its rear cover.
• The cover may not be seated properly. There is a tongue on the bottom corner of
the cover. Insert the tongue into the groove on the projector and the rest of the
cover will snap into place.
The image is tinted or discolored.
• The wall or surface you're projecting onto is colored. Try projecting onto a white
wall or surface.
• The lens may be dirty. Use a dry cotton swab to clean it off.
Focusing the Image
The image is blurry.
• Use the focus wheel on the side of the projector (next to the lens) to sharpen the
image.
• Reduce the input resolution. The native resolution of projector is 480p. Therefore,
resolutions greater that 720p may appear blurry.
• If you are closer to the projected image than the projector, you might be seeing the
individual pixels that make up the image. Reduce the size of the image or move
away from the image.
The image is too dim.
• Reduce the image size and/ or decrease (darken) the room lighting.

   Find Your Products By Category