Altec Lansing Stereo System IMT800 User Manual

5.0

Out of 1 Ratings

Owner's of the Altec Lansing Stereo System IMT800 gave it a score of 5.0 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    5.0 out of 5

  • Maintenance

    5.0 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    5.0 out of 5
of 24
 
4
Getting Started
How to Install the AC Adapter
1 Connect the AC adapter cable plug
into the speaker system’s jack.
The jack is located on the back of the
system.
2 Plug the AC adapter into the wall
outlet.
How to Install the Speaker Batteries
Your Altec Lansing Mix speaker system can also be powered by 8 D-size
(LR20) batteries (not included). To install the batteries, follow the steps below:
1 Make sure that there is no iPhone
or iPod in the system’s dock
and that no other devices are
connected to the system.
2 Unplug the AC adapter from the
Mix speaker system.
3 Open the battery compartment.
The battery door is located on the
bottom of the Mix speaker system. To access it, place the unit on its
back, so that the speakers are facing the ceiling. Then simply pull the
tabs to open the battery compartment.
Caution: Do not place the unit on its top side. This may damage the
volume knob.
4 Install 8 D-size (LR20) batteries (not included) in the battery
compartment.
Make sure the batteries are correctly installed as illustrated in the
battery compartment. The batteries will provide up to 30 hours of
continuous playing time.
5 Replace the battery door.
NOTE Please discard used batteries properly.
NOTE When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off to conserve
electricity.
How to Install the Clip-On Remote Battery
The clip-on remote battery (included) is not installed at the factory. To install
the battery, follow the steps below. The battery compartment is at the back
of the remote. Push the battery compartment door in the direction of the
arrow to unlock it.
1 Open the battery door.
The battery door is located on the back
of the remote. Using your thumb, push
the battery door toward the carabiner
clip. Then lift the battery door open.
2 Position the battery (included) so it
sits in the battery holder correctly.
Make sure the polarity (the + and – sides of the battery) is correct.
3 Replace the battery door.
NOTE Please discard used batteries properly.

   Find Your Products By Category