Anchor Audio Portable Speaker AN-130 User Manual

0

Out of 0 Ratings

Owner's of the Anchor Audio Portable Speaker AN-130 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 4
 
BASIC SYSTEM OPERATION
The AN-130 monitor is used to amplify the signal from a
microphone, electronic musical instrument or line-level sources
(cassette, CD, VCR, etc).
You’ll need a connection cable and an AC outlet.
1. Place the AN-130 in desired location
2. Set volume control on front of speaker to minimum
3. Plug the power cord into a grounded 115 volt outlet
(220 volt outlet for export model)
4. Plug a microphone into the MIC input jack, or an audio
source into a LINE IN jack
5. Turn the power switch on the rear panel “ON”
(red LED on front panel should light)
6. Adjust the volume, bass & treble controls to desired levels
IMPORTANT: To avoid feedback, do not position
a microphone in front of speaker.
AN-130 ACCESSORIES
REMOTE-130 - Wireless Remote Control
Controls volume level and mute for the AN-130RC.
MIC-90P - Handheld Microphone
Anchor’s dynamic, balanced, low impedance micro-
phone with a unidirectional pick-up pattern. It has a
on/off switch and comes with a 20’ cable and mic clip.
SS-250 - Speaker Stand
Adjustable stand made of black, anodized aluminum.
MSB-201 - Combo Mic/Speaker Stand
Floor stand w/ 33” adjustable boom. Speaker stand
when combined w/ SB-1 mounting bracket.
HS-1 - Carry Handle
Convenient attachable handle for AN-130.
HC-1550 - Hard Case
Traveling hard case, holds up to two AN-130’s,
two mics & accessories.
HC-1610B - Hard Case
Projector Protector hard case - holds projector,
AN-130 and mic.
CC-100 - Carry Bag
Cordura nylon bag w/ storage compartment.
SB-1 - Swivel Stand Mounting Bracket
Mounts the AN-130 to a wall, ceiling or on a speaker
stand. Spekaer stand adapter included.
SB-3 - Swivel Wall Mounting Bracket
Mounts the AN-130 to the wall or ceiling.
SB-360 - Swivel (360
o
) Wall Mounting Bracket
Mounts the AN-130 to the wall or ceiling.
RM-1 / RM-12 - Single / Dual Rackmount Kits
Mounts AN-130 monitors in a standard equipment
rack, three spaces high or 5-1/4”. All kits include
mounting hardware and are adjustable front & back.
5
NOTE: SEE PAGE 6
FOR WIRELESS RECEIVER
INSTRUCTIONS
MIC IN
An unbalanced, low impedance
microphone input is for use with
the MIC-90P or other mics that
have a 1/4” phone plug.
LINE IN
The line-level RCA input jacks may be used with audio sources such as computers, VCR’s, and
cassette tape or compact disc players. The inputs may be used for two separate sources, or
they may be used to sum L+R stereo outputs to a mono signal without the need for adapters.
LINE OUT
The unbalanced Line-out provides a combined signal of all inputs
being used. You can use this function to record your presentation
or to “daisy chain” another powered sound system to the AN-130
for greater crowd coverage.
Note: This output is post source level; any volume fluctuations for a
specific input will affect the output signal level at this output.
AN-130
CONTROL PANEL
Model Shown: AN-130U1
POWER SWITCH
POWER CORD
PROBLEMS? Consult the troubleshooting section
on the back page of this manual.
CAUTION: ALWAYS use shielded audio cables on
input connections to prevent interference.
NOTE: For UHF Wireless microphones
& transmitters see page 6.

   Find Your Products By Category