Atlona Building Set DVI to VGA or Component Scaler with DVI loop-out User Manual

0

Out of 0 Ratings

Owner's of the Atlona Building Set DVI to VGA or Component Scaler with DVI loop-out gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 11
 
1. Front Panel
1. DVI BYPASS: The DVI Bypass allows users to connect a local display. The resolution on the bypass output
would be the same as incoming resolution.
2. IR receiver: IR receiver picks up IR signal from the included remote control
3. PC & HD LED Indicator: These LEDs shows the output selection timing format. Only one Red LED will illumi-
nate according to the setting.
4. Menu & +/- buttons: Press menu button to show On Screen Display selection on the display and press +
or – buttons to move to your desire setting.
5. Power button & LED Indicator: Press this button to switch on the desired device or set it to standby mode.
The LED will illuminate in green when the power is on and red when power is off.
2. Rear Panel
1. DC 5V: Plug the 5V DC power supply into the unit and connect the adaptor to an AC wall outlet.
2. OUTPUT Cr/Pr, Cb/Pb & Y/HD: Connect a component video display to this output
3. OUTPUT PC: Connect a VGA cable to a monitor
4. INPUT DVI: Connect with DVI cable from your source
PANEL DESCRIPTION
1 5 2 3 4
1 2 3 4
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
4

   Find Your Products By Category