Atlona Marine Radio Atlona HDBaseT Wall Plate Receiver w/RS-232, IR, and Ethernet User Manual

0

Out of 0 Ratings

Owner's of the Atlona Marine Radio Atlona HDBaseT Wall Plate Receiver w/RS-232, IR, and Ethernet gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 13
 
4
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
LINK
FW
HDMI OUT
ETHERNET
AT-HDWP-RSNET
PWR
IR IN
RS232
IR
IR OUT
-
+
RX
TX
Panel Description
1. HDMI Out Port: Connect to HDMI display.
2. IR IN Port: Connect included IR receiver to this port.
3. IR OUT Port: Use the included IR Emitter for this port.
4. Ethernet Port: Bi-directional Ethernet pass through, send signal from a router to a source or to a
display.
5. Green Power LED: Power indicator. If plugged in, light will remain solid. If LED starts blinking
power is intermittent or there is a problem with the cable. If LED is off, no power is passing from
the transmitter (check the outlet on the transmitter or check the CAT cable).
6. Yellow Link LED: Signal Indicator for the CAT5e/6/7 IN port. LED will remain solid, unless there
is an issue with the cable or signal, then it will blink.
7. Firmware Update Port: Use Mini USB to USB A cable to connect to a Windows computer to
update.
8. RS-232 Port: Receive signal from a control system or PC.
9. CAT5e/6/7 IN Port: Connect category cable from here to a compatible transmitter.
Ex. AT-HDTX-RSNET (recommended), AT-HDCAT-8ED, etc.
4
1
2 3
65 87 9
Electrical Box
Compatible electrical boxes (see below)
Type: Plastic old-work electrical box or mud ring
Size: 2 Gang
Dimensions: Inner opening must be greater than 3.58” wide and 2.68” high

   Find Your Products By Category