Atlona Portable Generator Atlona Portable HDMI Signal Generator with 3D Patterns User Manual

0

Out of 0 Ratings

Owner's of the Atlona Portable Generator Atlona Portable HDMI Signal Generator with 3D Patterns gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 12
 
4
1 2 3 4 5 6 7 8 9 10
1. DC 5V: Input port for the included 5V DC Adapter.
2. Power Switch: Turns the AT-HD800 on (switch up) and off (switch down)
Note: To switch to power over 5V DC adapter, when the batteries are low, power cycle the
AT-HD800 with the power switch.
3. HDMI IN: Connect an HDMI cable from a source, or HDMI loop for cable testing.
4. HDMI OUT: Connect an HDMI cable to a display, or HDMI loop for cable testing.
Note: Loop the HDMI cable from the HDMI Out to the HDMI In for cable testing.
5. BATT. LOW LED: Red led will light up when the power is on. The LED will start flashing fast
when the batteries get to 10% or below or slow when it is put in standby mode.
Note: Standby will occur after 3 minutes of inactivity with nothing plugged into the ports of
the AT-HD800. (The AT-HD800 will not go into standby when using the 5V adapter.)
6. Bypass/Pattern LED: Green LED will illuminate when receiving signal from an HDMI source.
LED will be off if no HDMI source is connected.
7. 3D/PC/HD LED:
a. LED will flash when receiving or sending a 3D signal.
b. LED will be a solid green when sending or receiving a VESA resolution
c. LED will be off when receiving or sending a video resolution.
8. 50/60 Hz LED: Will illuminate green when sending/receiving a 50Hz signal.
(Most commonly used in Europe and Asia)
Note: To quickly switch between 50 & 60Hz press and hold the Timing Select & Info Pattern
buttons together for 3 seconds then release.
9. Timing Select Button: Press once to bring up the resolution menu on the display (not
available when an HDMI source is connected). Press the timing select button again to
go through the 25 available timing/resolutions (press the Info Pattern button to go
backwards)
10. Info Pattern Button
a. HD800 to Display: Press once to bring up the pattern menu. Press continuously to go
through the patterns. (Press the Timing Select Button to go back to a pattern.)
b. Source to HD800 to Display: Pressing the Info Pattern Button will show the source
and display capabilities side by side on the display’s screen.
Note: If there is no image present, press the Info Pattern Button 3 seconds then release. The
resolution will be reset to the Display’s native resolution.
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Panel Description

   Find Your Products By Category