AT&T Telephone CL84200 User Manual

2.8

Out of 2 Ratings

Owner's of the AT&T Telephone CL84200 gave it a score of 2.8 out of 5. Here's how the scores stacked up:

  • Reliability

    2.5 out of 5

  • Durability

    3.0 out of 5

  • Maintenance

    2.5 out of 5

  • Performance

    3.0 out of 5

  • Ease of Use

    3.0 out of 5
of 34
 
6
Battery installation and charging
Install the battery as shown on page 7. Once you have installed
the battery, the screen indicates the battery status (see table
below). If necessary, place the handset in the telephone base or
charger to charge the battery. For best performance, keep the
handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See
the table on page 29 for battery operating times.
If the screen shows Low battery, you need to charge the handset
without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following
table summarizes the battery charge indicators and actions to take.
Getting started
Battery indicators Battery status Action
The screen is blank
or shows
Place in charger.
Battery has no or
very little charge. The
handset cannot be used.
Charge without interruption until
the screen shows Low battery
or HANDSET X (at least 30
minutes).
The screen shows
Low battery and
flashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption until
the screen shows HANDSET X (at
least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base or
charger when not in use.
NOTE: If you are on a phone call in low battery mode, you hear four short
beeps every minute.

   Find Your Products By Category