Axis Communications Security Camera 25734 User Manual

0

Out of 0 Ratings

Owner's of the Axis Communications Security Camera 25734 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 14
 
- 3 -
!
!
ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):
NOTE: This unit is designed for operation in an
upright position. Installing the unit upside
down may cause damage to the internal
equipment, and will void the warranty.
Be sure the bracket is properly and securely
mounted to a supporting structure capable of
rigidly holding the weight of the entire unit.
GENERAL INSTRUCTIONS:
Tools Required: .100" Flat Head Screwdriver
Phillips Head Screwdriver
Listed on the following pages are the specic instructions
for each of the individual network cameras. See specic
instruction for the model that matches the unit you have.
Picture 1
Teon Tape
ASSEMBLING THE PRODUCT:
1. Remove the contents of the box onto a table. The larger
subassembly box is the housing assembly. The smaller
subassembly box is the dome assembly. (Picture 1)
3, Open the dome assembly box. Note there is a protection
lm on the dome. DO NOT REMOVE the lm until the
product is fully assembled and installed. This lm protects
the dome from scratches during installation. (Picture 3)
4. There is a safety lanyard that is attached to the inside of
the
housing assembly. Remove the phillips head screw on the
trim ring assembly and then attach the lanyard to the trim
ring with the phillips head screw.
5. The safety lanyard is now attached to the housing
(Picture 5).
Picture 5
Picture 2
2. Open the housing assembly box. Note there is a small roll
of Teon Tape that will be needed during installation, put it
aside. (Picture 2)
Attach Lanyard
to Trim Ring
Picture 3
Power 24VAC, Class 2 Only
52 watts at 24 VAC (accessories)
Heater: 50 watts
Blower: 2 watts

   Find Your Products By Category