Bushnell Binoculars Bushnell Binoculars User Manual

0

Out of 0 Ratings

Owner's of the Bushnell Binoculars Bushnell Binoculars gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 76
 
the ranging capabilities of the unit. e less light (e.g. overcast skies) the farther the unit’s maximum range will be.
Conversely, very sunny days will decrease the unit’s maximum range.
GETTING STARTED
INSERTING THE BATTERY
Remove the Posi-read™ battery door by lifting the battery door tab and then rotating counter clockwise. Insert a
CR-2 3-volt lithium battery into the compartment positive end rst, then replace the battery cap.
NOTE: It is recommended that the battery be replaced at least once every 12 months.
OPERATIONAL SUMMARY
While looking through the 4x eyepiece, depress the power button once to activate the in-view Liquid Crystal
Display (LCD). Place the aiming circle (located in the center of the eld of view) upon a target at least 7 yards away,
depress and hold the power button down until the range reading is displayed near the bottom of the in-view display.
Crosshairs surrounding the aiming circle indicate that the laser is being transmitted. Once a range has been acquired,
you can release the power button. e crosshairs surrounding the aiming circle will disappear once the power button
has been released or a distance has been displayed (i.e. the laser is no longer being transmitted). Note: Once activated,
the LCD will remain active and display the last distance measurement for 30 seconds. You can depress the power
button again at any time to distance to a new target. As with any laser device, it is not recommended to directly view
the emissions for long periods of time with magnied lenses. e maximum time the laser is transmitted (red) is 10
seconds. To re-re, press the button down again.
4

   Find Your Products By Category