Kalorik Iron KALORIK User Manual

0

Out of 0 Ratings

Owner's of the Kalorik Iron KALORIK gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 35
 
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
7 STP 30138 - 120501
Assembly page 7/35
Fax +32 2 359 95 50
position. Do NOT use the burn of steam function when the steam
press is closed, or you may damage the unit.
•
Do not press the burst of steam button (6) for more than 5
seconds or water may drip on your garment.
•
The handle (1) is equipped with 2 steam burst buttons (6), in order
for the press to be used easily by right-handed or left-handed
people.
PRESSING
• Make sure the locking knob (5) is in the open position (UNLOCK).
• Lift the handle (1). The pressing plate (2) moves to the up position.
• Carefully arrange the garment to be pressed onto the ironing
board (3).
Note: Avoid contact with the hot plate at any time!
• Grasp the handle of the pressing plate (2) and lower it onto the
ironing board (3), capturing the garment between the two halves
of the steam press.
• For lightly creased garments, simply lowering the handle and
allowing the pressing plate to rest on the ironing board for a few
seconds will be sufficient. Return then to the open position.
• For very creased garments, continue to grasp the handle and
push it downwards completely, until the pressing plate is pushed
to its lowest position. Then open the press.
• If the temperature is set high enough you may give the fabric a
burst of steam by pressing the burst of steam button (6) to
remove stubborn wrinkles.
Caution: For bursts of steam, lower the pressing plate until it is about
two inches from the garment, not completely down! Press the burst
of steam button for about 3-5 seconds. After releasing the burst of
steam button you may fully lower the pressing plate.
Note: Do not press the burst of steam button when the pressing plate
is in its lowest (closed) position.
• After a few seconds, lift the handle and bring the pressing plate
back to the raised position.

   Find Your Products By Category