4.1

Out of 5 Ratings

Owner's of the AT&T Cordless Telephone CL82450 gave it a score of 4.1 out of 5. Here's how the scores stacked up:
  • Reliability

    4.2 out of 5
  • Durability

    4.0 out of 5
  • Maintenance

    4.2 out of 5
  • Performance

    4.0 out of 5
  • Ease of Use

    4.0 out of 5
of 79
 
6
Battery indicators Battery status Action
The screen is blank or
shows Place in charger and
(flashing).
Battery has no or very
little charge. The handset
cannot be used.
Charge without interruption until
the screen shows Low battery or
HANDSET X (at least 30 minutes).
The screen shows
Low battery and (flashing).
Battery has enough charge
to be used for a short time.
Charge without interruption until
the screen shows HANDSET X
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base or
charger when not in use.
Battery installation and charging
Install the battery as shown below. Once you have installed the battery, the
screen indicates the battery status (see table below). If necessary, place the
handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the telephone base or charger when not in
use. The battery is fully charged after 16 hours of continuous charging. See
the table on page 70 for battery operating times.
If the screen shows Place in charger and flashes, you need to charge the
handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table
summarizes the battery charge indicators and actions to take.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment, matching
the color-coded label.
Insert the supplied
battery with the label
THIS SIDE UP facing up
as indicated.
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
Getting started