AT&T Cordless Telephone CL82450 User Manual

4.1

Out of 5 Ratings

Owner's of the AT&T Cordless Telephone CL82450 gave it a score of 4.1 out of 5. Here's how the scores stacked up:

  • Reliability

    4.2 out of 5

  • Durability

    4.0 out of 5

  • Maintenance

    4.2 out of 5

  • Performance

    4.0 out of 5

  • Ease of Use

    4.0 out of 5
of 79
 
41
Message capacity
The answering system can record up to 99 messages, depending on the
length of each message. Individual messages can be up to four minutes,
and the maximum recording time is approximately 14 minutes. The actual
recording time depends on individual message characteristics. Messages
remain available for replay until you delete them.
When there are new messages (including memos) on the answering system,
the number of messages stored flashes in the message counter.
If the answering system has three minutes of recording time left, it
announces, “Less than three minutes to record,” before message playback
at the handset or the telephone base. The handset screen displays Less
than 3 minutes to record before message playback. If the memory is low,
Rec mem low displays on the handset screen in idle mode. When you turn
on the answering system at the telephone base, it announces, “Calls will be
answered. Less than three minutes to record.”
If the memory is full, the answering system announces, “Memory is full,” before
message playback. The handset screen displays Rec mem full in idle mode and
the number of messages and F flashe alternately in the message counter at
the telephone base. You cannot turn on the answering system and record new
messages until old ones have been deleted. Memory full displays if you want
to turn on the answering system on the handset but there is no memory.
Voice prompts
The system provides voice prompts to guide you through the setup
procedures at the telephone base, message playback, remote access and
recording outgoing announcements.
Call screening at the telephone base
If the answering system and call screening are on, the announcement and
the incoming message broadcast at the telephone base when a call arrives.
You can turn call screening on or off using the handset (see page 18). When
call screening is off, you can temporarily turn on call screening by pressing
pVOLUME on the telephone base. Call screening will be off for the next
incoming call.
If call screening is on and you want to silence the telephone base while it
is recording messages, press qVOLUME on the telephone base until the
displays shows 1. This volume setting is shared with message playback, so
when you play messages at volume 1, they play at a very low volume. If you
increase the volume for playback, the next incoming message plays at the
same volume level.
About the answering system
Answering system

   Find Your Products By Category