Cisco Systems Riding Toy Cisco Firewall User Manual

0

Out of 0 Ratings

Owner's of the Cisco Systems Riding Toy Cisco Firewall gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 42
 
34
Step 3 Connect the inside, outside, or perimeter network cables to the interface ports. Starting from
the top left, the connectors are Ethernet 2, Ethernet 3, Ethernet 4, and Ethernet 5. The
maximum number of allowed interfaces is six with an unrestricted license.
Note Do not add a single-port circuit board in the extra slot below the four-port circuit board
because the maximum number of allowed interfaces is six.
Step 4 Power on the unit from the switch at the rear to start the PIX 515E. Do not power on the
failover units until the active unit is configured.
Check the LEDs
Table 1 PIX 515E Front Panel LEDs
LED Color State Description
POWER Green On On when the unit has power.
ACT Green On On when the unit is the active failover unit. If failover is present,
the light is on when the unit is the active unit.
Off Off when the unit is in standby mode. If failover is not enabled, this
light is off.
NETWORK Green Flashing On when at least one network interface is passing traffic.
POWER ACT NETWORK
97779

   Find Your Products By Category