Crestron electronic Marine Sanitation System QUICK MEDIA DISTRIBUTION CENTER User Manual

0

Out of 0 Ratings

Owner's of the Crestron electronic Marine Sanitation System QUICK MEDIA DISTRIBUTION CENTER gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 40
 
QuickMedia Distribution System Crestron QM-MD4x2
While in the system mode, pressing V will indicate where the video portion of a
signal is routed. For more information on the MD4x2’s operating modes, refer to
“Operating Modes” on page 28.
SYS (System)
Press this button to set the MD4x2 to the system mode. When the accompanying
LED is illuminated, all switching functions are controlled by the Crestron control
system. While in the system mode, routing paths for each input can be viewed on the
front panel by pressing an input or output button. For more information on the
MD4x2’s operating modes, refer to “Operating Modes” on page 28.
LOCAL
Press this button to set the MD4x2 to the local mode. When the accompanying LED
is illuminated, all switching functions are controlled by MD4x2’s front panel. For
more information on the MD4x2’s operating modes, refer to “Operating Modes” on
page 28.
ENTER
When switching signals in the local mode, switch changes are not implemented until
the ENTER button is pressed. After selecting an input source and an output
destination, press ENTER to implement the change.
IN (1 through 4)
Select a QM input source to view or switch (depending on the selected operating
mode) by pressing the corresponding IN button. If audio break is enabled (indicated
by the AUDIO BREAK LED), only the audio or video portion (indicated by the A or
V LED) will be switched or viewed (depending on the selected mode). For
information on operating modes and selecting QM input sources, refer to “Operation”
on page 28.
OUT (1 & 2)
Select a QM output destination to view or switch (depending on the selected
operating mode) by pressing the corresponding OUT button. If audio break is
enabled (indicated by the AUDIO BREAK LED), only the audio or video portion
(indicated by the A or V LED) will be switched or viewed (depending on the selected
mode). For information on operating modes and selecting QM output destinations,
refer to “Operation” on page 28.
SETUP LED and Pushbutton
The MD4x2 is TSID ready. Located on the rear of the MD4x2, the SETUP
pushbutton and its associated LED are located on the rear panel and are used for
setting up the unit’s network ID during the initial configuration of a Cresnet system
or when the device is being added/replaced. Refer to “Method B (Touch Settable
ID)” on page 13 for detailed information.
8 • QuickMedia Distribution System: QM-MD4x2 Operations Guide - DOC. 6278

   Find Your Products By Category