Beltronics Radar Detector Sti r Plus User Manual

0

Out of 0 Ratings

Owner's of the Beltronics Radar Detector Sti r Plus gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 16
 
26 27
Problem
• STiR Plus beeps briefly at the
same location every day, but no
radar source is in sight.
• STiR Plus does not seem
sensitive to radar or laser.
• STiR Plus did not alert when a
police car was in view.
• STiR Plus only beeped twice
during a radar encounter.
• STiR Plus’ audible alerts are
less loud after the first few
alerts.
• STiR Plus’s power-on
sequence reoccurs while you
are driving.
• Your 14-year old son has
changed all of your Settings.
• STiR Plus will not turn on.
Solution
• An X or K-band motion sensor or intrusion alarm is
located within range of your route. You can manually
lock this out using TrueLock, or allow AutoLock to do
it over time.
• STiR Plus may be in AutoScn or City Nox mode.
• VASCAR, (Visual Average Speed Computer And
Recorder) a stopwatch method of speed detection,
may be in use.
• This is normal. Full alerts are minimized when
traveling below 20 mph.
• STiR Plus is in AutoMute Mode. See page 4 for
details.
• A loose power connection can cause STiR Plus to be
briefly disconnected, and will retrigger the power-on
sequence.
• You can return all of the Settings to their factory
defaults by holding down the SENS and VOL buttons
while you turn STiR Plus on.
• Check that the PWR button is ON.
• Check that vehicle ignition is ON.
• Check all connections.
Explanation of Displays
Check
Receiver
Wiring
CNX
H
PilotHWY
WorkZone
Caution
Receiver
Error
GPS N/A
Troubleshooting
There is a problem with the front receiver (it could be an unplugged
connection, damaged wiring, or a problem within the front receiver
itself). STiR Plus will continue to display this message, and will not
operate until the problem has been repaired.
Sensitivity control is in City No X-band. (page 7)
Sensitivity control is in Highway mode. (page 14)
One of the many options in Settings (pages 12-16)
One of the many Safety Radar messages (pages 24-25)
STiR Plus has detected a Safety Radar Signal, but the signal isn’t yet
strong enough to decode the specific safety message (pages 24-25)
STiR Plus has failed to calibrate. Contact your Dealer for repair.
Not able to receiver GPS s
ignal. Check GPS antenna connection.

   Find Your Products By Category