Cisco Systems Boat Cisco Systems Boat User Manual

0

Out of 0 Ratings

Owner's of the Cisco Systems Boat Cisco Systems Boat gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 128
 
3-16
Cisco Catalyst 4900M Switch Installation Guide
78 -18 35 0- 0 2
Chapte r 3 Installing the Switch
Configurable Modules
To remove a switching module from a Catalyst 4900M series switch, perform the following steps:
Step 1 Disconnect any network interface cables attached to the ports on the switching module that you intend
to remove.
Step 2 Loosen the captive installation screws. (See Figure 3-10.)
Figure 3-10 Captive Installation Screws and Ejector Levers
Step 3 Grasp the left and right ejector levers, and simultaneously pivot the levers downward to release the
switching module from the backplane connector.
Step 4 Grasp the front panel of the switching module with one hand, and place your other hand under the carrier
to support and guide it out of the slot. Do not touch the printed circuit boards or the connector pins.
Step 5 Carefully pu ll the switching module straight ou t of the slot, keeping your other hand under the carrier to
guide it.
Step 6 Place the switching module on an antistatic mat or antistatic foam, or immediately install it in another
slot.
Step 7 If the slot is to remain empty, install a switching-module filler plate.
1 Captive screw 2 Ejector lever
232517
2
1
1
2

   Find Your Products By Category